Manufacturing Engineering

What is a Hydraulic Power Unit?

Hydraulic Power Units are the main driving components of hydraulic systems. Consisting mainly of a motor, a reservoir and a hydraulic pump, these units can generate a tremendous amount of power to drive most any kind of hydraulic ram. Hydraulic Power Units are based on Pascal’s law of physics, drawing their power from ratios of …

What is a Hydraulic Power Unit? Read More »

BALL VALVES

A ball valve, also known as a spherical valve, is a stopcock mechanism used to regulate the flow of a piped fluid and is characterised by having a perforated ball inside as its regulating mechanism.The mechanism is opened by turning the stem linked to the ball, allowing the fluid to pass by aligning the hole in the …

BALL VALVES Read More »

slotting machine parts

A slotter machine consists of these following parts: Base. Column. Saddle. Cross-slide. Rotating or Circular table. Ram and tool head. Ram drive. Feed drive. Bed or case: Bed or case is made up of cast iron. It supports column, tables, ram, driving mechanism, etc. the top of the bed carries horizontal ways which the worktable can transverse. Cross-slide: Cross-slide can …

slotting machine parts Read More »

what is a needle valve

Needle valves are used to restrict and control flow rates. These valves normally consist of a body with a tapered needle within a seat. To adjust the flow rate, the needle is screwed in or out via the adjustment knob. Needle valves are very common and are available in different sizes,flow rates, sensitivities, and ports. …

what is a needle valve Read More »

pipe support types

It is very important to properly support installed piping. Improperly supported pipe can result in the transmission of excessive noise into the frame of the building, reoccurring leaks, cracking, and, in extreme cases, buckling. Pipe should be supported by some type of commercial pipe hangers. There are a variety of systems on the market, and …

pipe support types Read More »

hose connector

Along with hoses comes a requirement for hose connectors. There are a myriad of different types and sizes of hose connections that are perfectly suitable for compressed air. However, there are only few basic connectors that are typically used. above Figure shows two different male NPT × hose barb fittings. The combination nipple is a …

hose connector Read More »

hose clamp

Most commercial hose assemblies are delivered with sleeve-type hose clamps. These type of clamps are inexpensive, quick to assemble, and attractive. However, they do have a couple of drawbacks. They can’t be tightened up when the assembly starts to leak, which leaves replacement as the only option. This brings to light their next problem—sleeve clamps …

hose clamp Read More »

retractable hose

Overhead retractable hoses are rather convenient in many situations. above Figure shows a retractable hose reel that may be hung from the ceiling or the wall. These reels are very useful and can be seen in almost every auto repair shop in the nation. below Figure shows a coil hose. These hoses are perfect for …

retractable hose Read More »

check valve

Check valves are important elements in any compression system. Singleand two-stage reciprocating compressors use a number of check valves in their systems. There is normally an input and output check valve in each pump head. These units will also incorporate an in-tank check valve, which is necessary during unload periods. Atypical in-tank check valve is …

check valve Read More »